Uji Performa Kolektor Surya dengan Variasi Pelat Absorber Berbentuk Segitiga dan Trapesium

Authors

  • Iskandar Departemen Teknik Mesin Universitas Andalas
  • Endri Yani Departemen Teknik Mesin Universitas Andalas
  • Zulkifli Amin Departemen Teknik Mesin Universitas Andalas
  • Lega Putri Utami Departemen Teknik Mesin Universitas Andalas

DOI:

https://doi.org/10.25077/inomet.3.2.14-19.2025

Keywords:

Energi Surya , Kolektor Surya , Absorber , Efisiensi

Abstract

Solar energy is a form of energy derived from solar radiation. One way to utilize solar energy is to heat water using a solar collector. The solar collector has an absorber plate to heat the water. The absorber is typically in the form of a flat plate, but some use a wave-shaped plate. In previous research, it was found that the shape of the flat plate was better than the shape of the corrugated absorber. This study aimed to determine the most suitable form of absorber for use in solar water heater collectors between two different waveforms. Where the waves are in the form of trapezoids and triangles

 A solar water heater was made with two different solar collectors. Then the data collection process is carried out, and the data is obtained. The study was conducted over a four-hour period, from 10:00 AM to 2:00 PM. Data collection is carried out every 30 minutes by adding water before heating and removing water after heating. The parameters measured were the inlet and outlet water temperatures, as well as the intensity of sunlight. The solar collector is also positioned at three different angles to determine which angle is most effective for heating solar water.

In solar water heating with a triangular absorber shape, an efficiency of 0.65 is obtained, while in a trapezoidal form, an efficiency of 0.74 is obtained. Then, at an angle of 10 degrees, the highest average efficiency for each solar collector ranges from 0.55 to 0.63. Thus, it can be concluded that a solar collector with a trapezoidal absorber shape is more effective than a triangular absorber solar collector at a slope of 10 degrees.

Downloads

Published

2025-12-31

Issue

Section

Articles