Analisa Pengaruh Variasi Sudut Potong Pahat dan Kecepatan Putar Mesin Bubut Terhadap Kekasaran Permukaan Stainless Steel 304

Authors

  • Berry Yuliandra Departemen Teknik Mesin Universitas Andalas
  • Rozan Putra Setriyan Departemen Teknik Mesin Universitas Andalas

DOI:

https://doi.org/10.25077/inomet.3.2.26-31.2025

Keywords:

Kekasaran Permukaan, Sudut potong pahat, Kecepatan putar, Stainless Steel 304, Mesin bubut

Abstract

Surface roughness is an important aspect in determining machining products quality. This aspect is influenced by various factors, including but not limited to machining parameters and cutting tool geometry. Stainless Steel 304 is one of the materials that has many applications in industry. Optimization of machining parameters and tool geometry is also important to produce a smoother surface on the material. This study tries to see the effect of variations in spindle speed and cutting angle on surface roughness in the turning process of Stainless Steel 304. The principal cutting edge angle variations are 40°, 60°, and 80°. Spindle speeds variations started from 280 rpm, 350 rpm, and 500 rpm. The control variables are 0.5 mm depth of cut and the feed rate of 0.11 mm/rev. The test results show that the 60° angle produces low and stable surface roughness at every variation of spindle speed. Surface roughness will also decrease with increasing spindle speed.

Downloads

Published

2025-12-31

Issue

Section

Articles