Kajian Nilai Kekasaran Permukaan Secara Teoritis dan Eksperimen pada Pembubutan Baja ST37 Serta Implikasinya pada Perencanaan Proses Pemesinan
DOI:
https://doi.org/10.25077/inomet.3.1.44-52.2025Keywords:
Kekasaran Permukaan, Persamaan GenerikAbstract
In machining-based industries, product precision is paramount, with surface roughness being a critical quality indicator. Achieving target roughness requires optimal cutting conditions, typically determined through operator experience or machining handbooks. However, these references often prove inadequate due to machining process complexity. Consequently, generic empirical equations are commonly employed in machining process planning, though they suffer from accuracy limitations that directly impact process outcomes. Despite these shortcomings, such equations remain widely used in cutting condition selection. This study evaluates the deviation magnitude induced by these equations and their implications for machining process planning. Experiments were conducted on ST37 steel workpieces using turning operations. Results indicate substantial discrepancies between predicted and actual surface roughness values, leading to inappropriate cutting condition selections. These inaccuracies may cause process failures, particularly when targeting medium-to-rough surface finishes in turning operations. While ANOVA analysis suggests the equation's predictions remain marginally acceptable, methodological improvements are essential to enhance machining condition estimation precision.
Downloads
Published
Issue
Section
License
Copyright (c) 2025 Jurnal Inovasi Rekayasa Mekanikal dan Termal

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
