Analisis Pengaruh Besar Jari-jari Kurvatur Roof Spoiler Terhadap Koefisien Drag pada Mobil Model Truk Menggunakan Computational Fluid Dynamic (CFD) Software
DOI:
https://doi.org/10.25077/inomet.2.2.59-66.2024Keywords:
Aerodynamics, Roof Spoiler, Trucks, Drag Coefficient, Computational Fluid Dynamic (CFD)Abstract
The geometric design of a vehicle greatly influences its aerodynamic performance. Larger vehicles, like trucks, often experience poor aerodynamic efficiency due to higher drag coefficients, which leads to increased drag and negatively impacts speed and fuel consumption. To counteract these issues, various methods, including the use of spoilers, have been explored. This study presents an innovative technique by adding a roof spoiler to a truck and adjusting the curvature radius of the spoiler. The aim is to analyze pressure and velocity contours and calculate the drag coefficient affected by different spoiler curvature radii. The study examines spoilers with curvature radii of 1.000 mm, 1.250 mm, 1.500 mm, 2.000 mm, 3.000 mm, 4.250 mm, and 9.000 mm, each measuring 820 mm in width, 520 mm in height, and 1.828 mm in length. Using the k-epsilon turbulence model, Computational Fluid Dynamics (CFD) simulations were carried out, and a grid independence test was conducted to minimize errors and enhance computational efficiency. The findings revealed that a roof spoiler with a curvature radius of 1.000 mm achieved the greatest drag reduction, averaging a 29% decrease, and reduced fuel consumption by up to 14,7%. In comparison, a spoiler with a curvature radius of 9.000 mm resulted in a 9,2% reduction in fuel consumption when compared to trucks without roof spoilers.
Downloads
Published
Issue
Section
License
Copyright (c) 2025 Jurnal Inovasi Rekayasa Mekanikal dan Termal

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
