Pengaruh Penambahan Degasser dan Serbuk Slagger pada Paduan Aluminium Silikon (Al-7%Si) - Strontium (0,045%Sr) terhadap Kekerasan dan Struktur Makro-Mikro Produk Pengecoran
DOI:
https://doi.org/10.25077/inomet.2.2.47-52.2024Keywords:
Aliminium-silikon , Degasser , Slagger , Porosity , HardnessAbstract
This study aims to analyze the effect of adding degasser and slagger powder on the hardness, macrostructure, and microstructure of aluminum-silicon alloy (Al-7%Si) modified with strontium (0.045%Sr) in the casting process. Variations in degasser concentration (4%, 6%, and 8%) and slagging powder (1%, 2%, and 3%) were applied to evaluate the porosity characteristics and hardness of the cast product. The results showed that degasser significantly influenced the porosity characteristics. The combination of 8% degasser without slagging powder yielded the best results, reducing the number of pores to 6,491, the average pore size to 0.777 mm, and the affected area to 8.625%. In terms of hardness, the highest value was observed in specimen 4 (Al-7%Si – 0.045%Sr, 8% degasser) with an average hardness of 90.86 HV. This high hardness was attributed to reduced trapped gas in the casting, leading to minimal porosity defects and strong atomic bonding at the grain boundary matrix. The absence of slagging powder also left impurities (Fe) in the cast product, further contributing to its increased hardness. Conversely, the lowest hardness value was recorded in specimen 5 (Al-7%Si – 0.045%Sr, 3% slagging powder) at 60.34 HV. The hardness results indicated a negative correlation between hardness and porosity distribution, and a positive correlation between hardness and impurity content (Fe) in the cast product. These findings highlight the importance of balancing degasser and slagging powder concentrations to optimize the quality of aluminum-silicon alloys for casting applications.
Downloads
Published
Issue
Section
License
Copyright (c) 2025 Jurnal Inovasi Rekayasa Mekanikal dan Termal

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
