Pebandingan Bentuk Permukaan Aus dari Kontak Sliding Antara Pelumas Berbahan Dasar Nabati Tanpa Zat Aditif dan Zat Aditif

Authors

  • Dedison Gasni Departemen Teknik Mesin Universitas Andalas

DOI:

https://doi.org/10.25077/inomet.2.2.34-40.2024

Keywords:

Kontak Sliding, Wear, Biolubricant, MWCNT, Span 60

Abstract

The surface quality of moving machine components that are in contact with each other will relatively affect the life of the machine components due to surface wear. Lubricants play an important role in reducing wear on contact surfaces. Nowadays, most lubricants come from synthetic oil and mineral oil, whils are not environmentally friendly, and as an alternative, environmentally friendly biolubricants can be used. In this research, the effect of adding additives to biolubricants will be investigated to see the quality of the contact surface caused by wear that occurs during contact sliding. Tests were carried out on a pin-on-disk test equipment with loads of 50 and 100 N with disk rotation of 500 and 1400 rpm. As a biobased lubricant, palm oil and additives in the form of MWCNT nanoparticles and Span 60 were used. The research results show that adding additives to the biolubricant can improve the quality of the contact surface by reducing the dimensions of the scar diameter, width, and surface depth of the disk. The addition of additives at 500 rpm provides better contact surface quality with fewer scars and a smaller surface depth.

Downloads

Published

2024-12-30

Issue

Section

Articles