The Preventive Maintenance dan Analisis Kegagalan Innert Part Gearbox Raw Mill
DOI:
https://doi.org/10.25077/inomet.1.1.49-54.2024Keywords:
Analisis Kegagalan, Preventive Maintenance, Innert Part, Gearbox, Bearing, DefectAbstract
In order to analyze failures, periodically during preventive maintenance it is necessary to collect data, such as thermal checks with a thermal imager, vibration checks using Vibxpert. One of the factory component tools that is checked is the raw mill gearbox, which is a box containing various gears that can be selected and used to regulate how fast or how hard the machine moves. In the inner part of the gearbox there are several engine components, one of which is the bearing. Bearings are machine elements that function to support a shaft so that the shaft can rotate without experiencing excessive friction. If the engine does not use bearings, it will cause friction between the shaft and the shaft seat, which will cause the engine to heat up quickly. When using bearings, you need to pay attention to several things so that later they don't cause failure which can be caused by unbalance, misalignment, bent shaft, looseness and so on. This failure can cause high vibration in the bearing, while high vibration is not expected because it will damage the bearing and shaft, so it is necessary to carry out an analysis regarding the occurrence of high vibration in the bearing which causes failure of the inner parts of the gearbox. High vibration in the pinion gear which has an impact on clutch gear wear. This research aims to determine the cause of failure in the inner part of the 4R1M02G1 raw mill gearbox. Checking and data collection was carried out using a thermal imager measuring tool for collecting thermal data, Vibxpert for collecting vibration data, Feeler Gauge for measuring gaps, CSi lubricant testing for testing lubricant samples, and Teodolite for measuring shaft alignment with the gearbox. Based on the analysis carried out, misalignment occurs due to wear of the clutch gear which makes the work of the clutch gear to accommodate several degrees of misalignment disappear and the shaft shifts when the engine is operating. The working load of the bearing increases to position the shaft on the correct axis, as a result the bearing wears out, defects and pitting form, until the outer bearing rotates. Defects and pitting in bearings cause wear/wear in lubrication with ferrous/metal content reaching alarm levels.
Downloads
Published
Issue
Section
License
Copyright (c) 2024 Jurnal Inovasi Rekayasa Mekanikal dan Termal

This work is licensed under a Creative Commons Attribution-NonCommercial-ShareAlike 4.0 International License.
